Top 10 MMDVM Hotspot Board – Single Board Computers

As an Amazon Associate I earn from qualifying purchases.

1. AURSINC

#ad

Pi 3, AURSINC MMDVM Hotspot Board +OLED+ Antenna Support UHF VHF Support P25 DMR YSF DSTAR NXDN POCSAG for Raspberry Pi-Zero W

#ad
AURSINC #ad - Support uhf vhf, 842mhz-950mhz depending on adf7021 and tcxo, frequency range: 144MHz-148MHz, 420MHz-475MHz, HAT firmware amateur radio brand license restrictions. Support online upgrade, user-friendly OLED and Nextion special design location, reserved for additional installation of Bluetooth modules. Support mmdvm mode dmr / dstar / ysf / p25 / nxdn / POCSAG. Support raspberry pi 3b, compatible with nanopi neo, Pi ZERO, 3b +, Orange Pi, compatible with BlueDV requires USBtoTTL or Bluetooth model. Save electricity, stable, High quality TCXO, low BER.
BrandAURSINC #ad
ManufacturerAURSINC #ad
Height1.18 Inches
Length3.94 Inches
Width2.76 Inches
Part Number202007

2. AURSINC

#ad

MMDVM Hotspot Board + Aluminium Case Support UHF VHF Support P25 DMR YSF DSTAR NXDN POCSAG for Raspberry Pi-Zero W, Pi 3

#ad
AURSINC #ad - Support vhf/uhf, 842mhz-950mhz depending on adf7021 and tcxo, 420MHz-475MHz, frequency range: 144MHz-148MHz, HAT firmware amateur radio brand license restrictions.

Save electricity, stable, low ber. Support raspberry pi 3b, pi zero, compatible with NanoPi NEO, orange pi, compatible with BlueDV requires USBtoTTL or Bluetooth model. Support online upgrade, user-friendly OLED and Nextion special design location, reserved for additional installation of Bluetooth modules. Support mmdvm mode dmr / ysf / p25 / nxdn / dstar / POCSAG. Note: this is not a completed or assembled Hotspot, High quality TCXO, it is just MMDVM Board with Aluminum case.
BrandAURSINC #ad
ManufacturerAURSINC #ad

3. Thincol

#ad

Hotspot Module, USB Wireless Multi-Mode Hotspot Expansion Board + Antenna + LED Screen + Case, for Raspberry Pi 3 and for Raspberry Pi 0 WA, Support D-Star / P25 Digital Mobile Radio UHF VHF

#ad
Thincol #ad - Notice: pi-star, you can get all the software and design support for this wifi hotspot from the MMDVM related open source website, USB power support; but it does not support analog radio USB.

Wifi ssid: gary / password: since pi zero w does not support 5. 8ghz, 2. 4ghz ssid is required. Support raspberry Pi 3, Raspberry Pi Zero W. Frequency band support: uhf vhf frequency range is 144mHz-148MHz, 420MHz-475MHz, 842MHz-950MHz;. Mmdvm hotspot board kit: wifi board and antenna kit, etc. Mmdvm mode and compatibility: d-star / p25 / DMR etc. It is simple, raspberry pi project development, is a portable wireless network router used for home WIFI, outdoor game parties, fast and convenient.
BrandThincol #ad
ManufacturerThincol #ad
Height0 Inches
Length0 Inches
Width0 Inches
Part NumberThincolma5vhsp4x9-11

4. HKCNMA

#ad

MMDVM Hotspot Support P25 DMR YSF + Aluminum Shell+ OLED + Antenna + Case no Raspberry Pie

#ad
HKCNMA #ad - Power supply: mobile charger or a usb cable connected to your computer or laptop. Wifi ssid:gary/password: need the 2. 4ghz ssid as the Pi Zero W doesn't support 5. 8ghz. The hotspot will also work mobile in your vehicle if you Tether it to your mobile phone network. Basic setup: set the same freq as radio Mobile,for example : 433. 550000mhz dmr. No raspberry pie, just motherboard + shell + screen + silk Suit for Raspberry Pi 3, Raspberry Pi Zero W. Support:d-star, p25, dmr and work with UHF.
BrandHKCNMA #ad
ManufacturerShenzhen Laihai Digital Technology Co., Ltd. #ad
Part Number20
Model20

5. Hima

#ad

Pi 3B+, Hima MMDVM Hotspot Spot Radio Station Antenna + MMDVM Expansion Board Support P25 DMR YSF D-Star UHF VHF WiFi Digital Voice Modem Suitable for Raspberry Pi-Zero W, Pi 3

#ad
Hima #ad - Package includes: high performance 32-bit ARM processor, SMA antenna connector, including antenna, 2 pins, 4 screws. Support for digital dashboards and PI-STAR web-based voice configuration tools. For raspberry pi 3, raspberry pi 3b+, raspberry Pi Zero W. The 40pin raspberry pie needs to insulate the middle 20pin pin headers for normal use. Material: PCB. Supports all four digital amateur modes DMR, D-Star, P25 and System Fusion.
BrandHima #ad
ManufacturerHima #ad
Part NumberEU-XB-MMDVM

6. AURSINC

#ad

AURSINC MMDVM Duplex Hotspot Module Dual Hat V1.3 Support P25 DMR YSF NXDN DMR Slot 1 + Slot 2 for Raspberry pi with USB Port Without OLED

#ad
AURSINC #ad - Modem select: stm32-dvm/mmdvm_hs-raspberry pi HatGPIO or any other GPIO board. High performace: 32-bit arm processor, up to 10mW RF power, fully tested every piece.

Frequency: radio frequency : freq:144-148, 842-950 note: tx =0, 219-225, main band 420-475, rx=0. Work with rasberry pi: mounts cleanly on current Raspberry Pi including the Pi Zero, NOT compatible with Rasberry Pi 4. Widely compatible: supports DMR, P-25, D-Star and System Fusion. Update new fw: pi-star / ssh access / expert / user :pi-star pass:raspberry then run sudo pistar-mmdvmhshatflash hs_dual_hat set Jumper BOOT0=1, BOOT1=0 and soler JP1 First! After upgraded finished, disconnect JP1.
BrandAURSINC #ad
ManufacturerAURSINC #ad
Part Number2020

7. AURSINC

#ad

AURSINC MMDVM Hotspot Board + Antenna Support UHF VHF Support P25 DMR YSF DSTAR NXDN POCSAG for Raspberry Pi-Zero W, Pi 3

#ad
AURSINC #ad - Support raspberry pi 3b, pi zero, 3b +, orange pi, compatible with nanopi neo, compatible with BlueDV requires USBtoTTL or Bluetooth model. Support uhf vhf, frequency range: 144mhz-148mhz, 842mhz-950mhz depending on adf7021 and tcxo, 420mhz-475mhz, HAT firmware amateur radio brand license restrictions. Support online upgrade, user-friendly OLED and Nextion special design location, reserved for additional installation of Bluetooth modules. Save electricity, high quality TCXO, stable, low BER. Support mmdvm mode dmr / nxdn / ysf / dstar / p25 / POCSAG.
BrandAURSINC #ad
ManufacturerAURSINC #ad
Height0.4 Inches
Length2.56 Inches
Width1.2 Inches

8. C4Lab

#ad

C4Lab, JRZ-1S case for Raspberry Pi Zero/Zero W & JumboSPOT or Lonestar MMDVM Simplex

#ad
C4Lab #ad - Full body coverage for raspberry pi, JumboSPOT or LoneStar MMDVM Simplex and OLED screen not waterproof. Enough room for. 96″ oled screen to be mounted directly to JumboSPOT or LoneStar MMDVM Simplex by customer. Cut outs for easy access to SD card and camera ports. Comes with 2 tops: one with antenna hole and one without. Pin-hole access to boot and reset buttons on top of case.
BrandC4Lab #ad
ManufacturerC4Labs #ad
Height1 Inches
Length3 Inches
Width2 Inches
Part NumberJRZ-1S-BLK
ModelJRZ-1S-BLK

9. SainSmart

#ad

Support P25 DMR YSF D-Star WiFi Digital Voice Modem Suitable for Raspberry Pi-Zero W, SainSmart MMDVM 2 Channels Hot Spot Shield with OLED+MMDVM Hotspot Spot Radio Station Antenna, Pi 3, Pi 3B

#ad
SainSmart #ad - Wifi digital voice modem for mmdvm hotspot spot radio, it is an easy, convenient and ready to use Multi-mode Hotspot that supports D-STAR/P25/DMR. Support for digital dashboards and PI-STAR web-based voice configuration tools. For normal use, the 40pin raspberry pie needs to insulate the middle 20pin pin headers. Supports all four digital amateur modes DMR, D-Star, P25 and System Fusion. It is compatible with raspberry Pi 3, Raspberry Pi 3b +, Raspberry Pi Zero W.
BrandSainSmart #ad
ManufacturerSainSmart #ad
Part Number101-30-418

10. Sanpyl

#ad

Hotspot Module Board, Jumbo Spot RTQ MMDVM Hotspot Support P25 DMR YSF+OLED Screen+Antenna+8G TFT Card,Fully Assembled and Tested Jumbo-Spot-RTQ with Acrylic EnclosureBlack

#ad
Sanpyl #ad - Support pi-star's web based digital voice dashboard and configuration tool. Support all four digital amateur modes DMR, D-Star, P25 and System Fusion. Built-in oled system status display indicating Mode, Talk Group and Call Sign. Console port ssh 22 for root level access to the operating system. Built-in led indicators for status of Power, PTT, COS and Mode.
BrandSanpyl #ad
ManufacturerSanpyl #ad
Height0.79 Inches
Length2.36 Inches
Width1.18 Inches
Part NumberSanpyl368ok4tmh2-01